![]() Then some manufacturers went to the red stuff, and VW/Audi went to some other stuff that sludges up if mixed with the green stuff.Ī couple years ago I bought an insurance auction VW Beetle TDI, and when I replaced the front end/radiator/etc., I flushed the engine out with water and switched the car to traditional green coolant. If you had a car with the brand new DexCool, it was recommended to drain it and refill with the green stuff. Back in the day, you could put green ethylene glycol coolant in every car and it worked fine. If in doubt seek a professional mechanic's advice.Over the years I’ve tinkered with a bunch of different cars. ![]() Always consult your user manual before attempting any sort of maintenance work on your vehicle. This article is for general information only and should not be used as a diagnostic tool. This is why regular inspections of your vehicle's fluid is recommended so that you have a good feeling for what is 'normal' for your system. The most important thing to remember is that every vehicle is different and as a result your antifreeze will deteriorate at a different rate to someone else's vehicle. A litmus test or a pH test will tell you if the antifreeze in your vehicle is too acidic. As the fluid deteriorates over time this has a tendency to become acidic which, if left unchecked, will cause damage to your engine - particularly the seals and gaskets, potentially leading to leaks. If your antifreeze looks like it has been watered down too much, or if you know that you have upset the dilution ratio in your tank over time then you should also consider changing your antifreeze.Īntifreeze is an alkali and if it is fresh then it will have a pH of 8.5-10. Similarly, if you have solely topped up with undiluted antifreeze then this will also have consequences for its effectiveness. If you are in the habit of topping up your antifreeze with plain water on a regular basis then the dilution rate of the fluid in your reservoir will provide less effective protection for your engine. ![]() You should be making sure that when you top up you are using the correct dilution of antifreeze to water as recommended in your manual. How you top up your antifreeze can have an impact on the lifespan of the fluid in your reservoir. It is important to top up your antifreeze at the recommended intervals specified in your user manual or when required if you check the levels in your vehicle during a fluid check. You should consider changing the liquid if the antifreeze has a muddy colour or consistency has noticeable amounts of debris in it or has an oily layer on the surface of the liquid. There may also be debris floating about in the antifreeze in the form of rust or carbon. Over time, your coolant will become dirty losing its colour and becoming darker, often an oxidized shade of brown. Fresh antifreeze is a clear brightly coloured liquid, usually blue, red, green, violet, yellow or orange but this will vary depending on the manufacturer's formulation. The easiest way to tell if your antifreeze needs changing is by checking the colour of the fluid. Your user manual should give you a guide as to when you can expect to need to change your antifreeze but it is a good idea to check up on the health of the fluid when you check if it needs a top-up, something you should be inspecting every three months or so. Before you set about checking the health of your antifreeze it is important to bare in mind that different vehicles will have different expected lifespans on any fluid that goes into the vehicle.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |